Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
11-11-2015, 03:13 PM | #1 | |
AF Newbie
Join Date: Nov 2015
Location: Morgantown, Pennsylvania
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
|
no start after replacing injector spider
I have a 96 ZR2 4.3L VIN W engine. original problem: rough idle, ran pretty good on highway, chk engine lite on, error code P300 random misfire. Just in general maint. I replaced fuel filter first. After replacing injector spider now engine will not start. Any help, comments would be so appreciated.
|
|
11-11-2015, 06:23 PM | #2 | |
A990 racer
Join Date: Mar 2002
Location: Chestertown, New York
Posts: 16,988
Thanks: 25
Thanked 380 Times in 372 Posts
|
Re: no start after replacing injector spider
Will it start sprayr car cleaner in to the intake? Go fuel pressure?
__________________
|
|
11-11-2015, 09:44 PM | #3 | |
AF Newbie
Thread starter
Join Date: Nov 2015
Location: Morgantown, Pennsylvania
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: no start after replacing injector spider
using starting fluid down the intake doesn't help
|
|
11-14-2015, 01:48 PM | #4 | |
AF Newbie
Thread starter
Join Date: Nov 2015
Location: Morgantown, Pennsylvania
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: no start after replacing injector spider
I had 1 and 3 plug wires reversed at distributor. Now it sounds like it wants to start. After spraying starting fluid, it runs for a short duration and stops. It would not run after turning key over a 2nd time. I have not verified that the injectors are spraying.
|
|
11-14-2015, 03:39 PM | #5 | |
Registered Offender
Join Date: Mar 2006
Location: Rural
Posts: 6,547
Thanks: 7
Thanked 345 Times in 340 Posts
|
Re: no start after replacing injector spider
Be certain the top electrical connector for the injector pod is fully seated. Those can be a bit tricky and stubborn to seat properly. All pins must align, as well as the body and lock tabs.
__________________
Permanent seat assignment on the Group W bench... Automotive Forums Survival Guide |
|
11-14-2015, 07:14 PM | #6 | |
AF Newbie
Thread starter
Join Date: Nov 2015
Location: Morgantown, Pennsylvania
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: no start after replacing injector spider
thank you blue bowtie for your comment, I will look at it more closely
|
|
11-16-2015, 03:11 PM | #7 | |
AF Newbie
Thread starter
Join Date: Nov 2015
Location: Morgantown, Pennsylvania
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: no start after replacing injector spider
Lastly, seen I had forgotten to reconnect MAF sensor and the other one. Now it starts and no longer have the rough idle. SES light is now off. Fairly confident that the replacement of the injector spider assy. was the fix. It is smooth throughout the entire RPM range.
|
|
|
POST REPLY TO THIS THREAD |
|
|