rear engine support module

I am trying to change ta bad mount on my 96 Cirrus. I have the engine support module loose from the front mount ( front of car) and from the firewall side mount. It looks like a rubber bushing that goes into the support bar. I can't seem to get the bar out no matter how I try. It is just laying loose but I can't drop it to get the new mount in!?

Please help!!

Thanks,
Bob

are you trying to change out the rear motor mount ?

are you trying to change out the rear motor mount ?

Yes I am. I have the 2.5 v-6 which has a bar connecting the front and rear mounts. The front one is bolted to the radiator core support and the rear one to the body , and I have those loose. I can't figure how to get the bar out to put the new mount in it.
The bar can't go back because it hits the steering rack assembly, and in the front it is close to the fans etc.
I would appreciate any advice I can get.

Thanks,
Bob

http://www.stratusphere.us/forums/index.php?showtopic=28756 look down where need4speed (http://www.stratusphere.us/forums/index.php?showuser=150) posted on a how to the the 2.5L V6

Wow! It looks like everybody is having a tough time with this one.

I have the bolt out of the rear bushing...but to get to the rearbracket assembly looks like the engine would have to be out!!

I think I might have to bite the bullet on this one! Just bolt everything back together and take it in someplace!!

Thanks for the help ... It is appreciated!!

Bob