93 dakota wont start

i have a problem, i have a 93 dakota 5.2 318, my winter truck. i went out to run it a little bit today and it wont start. it cranks very strong, but it wont start up. i need some help please!!!!!

Is there gas in it?

ha yea i just put about 3 gallons in and tried to start it again, pumping the gas

Pumping won't do anything. It's fuel injected.

Is the check engine light on?

Did you check for spark?

no check engine light, and there is no spark, now what?

Are you sure? Did you pull one of the plugs to see for sure if there is actually no spark? If not, the coil might be bad, or even a fuse could be blown or something.

This is your winter truck, right? I'm guessing you had it in storage or something eh? Mice could have eaten through a bunch of important wires...

yea me and my dad tested it and there is no spark. it was parked outside. it was started about every week or so until it stopped starting about 2 weeks ago. ill check the fuse, and we tested the coil also, it is good. ill check the fuses. could it be the computer, cause that went at about 60000 and it did the same thing?

Might be. The distributor pickup might be bad. Can you tell if power is making it as far as the distributor?

If you don't have any fire at the coil it will probably be the comp board. I just had to replace mine in my 93 5.2,but I have got almost 130,000 on it. Good luck!

there is no voltage getting to the coil

Computer.

whats the cheapest place to get a computer

Is there any way to remove Testors glue?

I'm having the same problem with my 95. Sat for weeks when I went to start it. It just turned over like it wasn't getting a fire . Did all of the above and it still will not start. If its the computer. Are you talking about the one on fender. I think they call it SBCM. Need help this is my winter truck.l

this is my winter truck too!!!! need it soon, wheres a good place to get a computer

It's either the SMEC or the SBEC; Single Module Engine controller or Singel Board Engine controller.

Any ideas on a good place to get one would be appreciated here to.

got the computer today, and still nothing!!!!! this is not good. there is still no voltage getting to the coil? Any more ideas would be great!!!! HELP PLEASE

got the computer today, and still nothing!!!!! this is not good. there is still no voltage getting to the coil? Any more ideas would be great!!!! HELP PLEASE

Was that a new or used computer you installed. And where did you get it?

new, from discount autoparts.com