Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
| Latest | 0 Rplys |
|
Show Printable Version | Email this Page | Subscribe to this Thread |
|
Thread Tools |
12-07-2005, 10:31 AM | #1 | |
AF Newbie
Join Date: Dec 2005
Location: Daytona Beach, Florida
Posts: 13
Thanks: 0
Thanked 0 Times in 0 Posts
|
98 blazer headlights flicker and brake lights out
At night with the lights fluctuate in synch with what sounds like the fuel pump ( a noise from the rear). The faster I drive the less it is noticable. If I am idle or in park the fluctuation is bad the dome dash and radio lights all flicker. Also my brakes lights just went out altogether all fuses and bulbs are good I already replaced the brake pedal switch and all the other lights work fine (park, turn, reverse). Any one familair at all with these problems. Ps onyone no a good method for changing the spark plugs and wires out?
|
|
12-07-2005, 12:30 PM | #2 | |
AF Enthusiast
Join Date: Aug 2005
Location: Honolulu, Hawaii
Posts: 531
Thanks: 0
Thanked 1 Time in 1 Post
|
Re: 98 blazer headlights flicker and brake lights out
Try taking a look at your alternator and see what the voltage out put is. With the motor at idle, it should be around 13.5 volts. If not, possible faulty alternator.
|
|
12-08-2005, 11:18 AM | #3 | |
AF Newbie
Join Date: Jul 2005
Location: Gardner, Kansas
Posts: 56
Thanks: 0
Thanked 0 Times in 0 Posts
|
The brake lights run thru the $365.71 Multi-function switch (turn signal switch)! Take a look in the back of the Chilton book for brake light wiring diagram.
I recently had to replace the turn signal switch on my '97 due to no brake lights - hazards, turn signals, headlights, wipers, cruise - all worked fine. Eliminated the Brake Switch and the BTSI (Brake Transmission Shift Interlock) solenoid: could shift from PARK with the brake depressed. Eliminated the Park-Lock solenoid: could remove key from ignition. I'm keeping to defective unit to disassemble to determine point/cause of failure. After a little more thought, I would start by disconnecting the battery, then unbolting the ignition/multi-function wiring harness under the dash, and using some good electrical contact cleaner - clean both sides of the wiring harness. Allow ample time to dry before reassembling and reconnecting the battery. Last edited by Brian_D; 12-08-2005 at 12:03 PM. |
|
|
POST REPLY TO THIS THREAD |
|
|