Automotive Forums .com - the leading automotive community online! Automotive Forums .com - the leading automotive community online!
Automotive Forums .com - the leading automotive community online! 
-
Latest | 0 Rplys
Go Back   Automotive Forums .com Car Chat > Ford > Five Hundred
Register FAQ Community Arcade Calendar
Reply Show Printable Version Show Printable Version | Email this Page Email this Page | Subscription Subscribe to this Thread
 
Thread Tools
Old 01-29-2017, 07:10 PM   #1
LagunaSeca
AF Newbie
 
Join Date: Jan 2017
Location: San Diego, California
Posts: 7
Thanks: 0
Thanked 1 Time in 1 Post
Voltage drop when starting

Hello, my son's gal has a Ford five hundred sedan and had been told by a "shop" that her starter was bad. I showed my son how to clean the battery terminals and then tested the voltage with my electrical tester. It showed 12.60 v at the battery which is good. When cranking the motor to start, the voltage typically dropped into the mid 11s, once into the high 10v range. As a comparison test, we did the same test to my 4 cylinder 1994 Camry and it went from 12.65 to the mid 11s as well when cranking, with about a year old Bosch top of line battery. Question - is a drop into the mid 11s or high 10s unacceptable when cranking the engine? Everything else seems unremarkable, nothing weird, and it starts within a few cranks. Thanks for your input.
LagunaSeca is offline   Reply With Quote
Old 01-29-2017, 08:06 PM   #2
aleekat
AF Enthusiast
 
Join Date: Dec 2001
Location: clarksville, Tennessee
Posts: 1,719
Thanks: 26
Thanked 185 Times in 181 Posts
Re: Voltage drop when starting

Normally 9v or less is an indication of battery issues. Clean terminals, tight, etc.
So why did she take it to the shop and the diagnosis of needing a starter?
__________________
Post back, that's what makes Forums Work.

Last edited by aleekat; 01-29-2017 at 09:16 PM.
aleekat is offline   Reply With Quote
Old 01-30-2017, 02:59 PM   #3
LagunaSeca
AF Newbie
Thread starter
 
Join Date: Jan 2017
Location: San Diego, California
Posts: 7
Thanks: 0
Thanked 1 Time in 1 Post
Re: Voltage drop when starting

I gather she stopped by Pep Boys to get her battery checked. She probably saw some ad or free promotion and they told her that the starter needed to be replaced as it was being hard on the battery. 12.65v at the battery looks good to me, and it seems to crank over fine. I just wasn't sure what the magic number was for voltage drop at a battery, what is acceptable for voltage when under starter load.
LagunaSeca is offline   Reply With Quote
Old 01-30-2017, 09:44 PM   #4
aleekat
AF Enthusiast
 
Join Date: Dec 2001
Location: clarksville, Tennessee
Posts: 1,719
Thanks: 26
Thanked 185 Times in 181 Posts
Re: Voltage drop when starting

__________________
Post back, that's what makes Forums Work.
aleekat is offline   Reply With Quote
Old 01-30-2017, 09:58 PM   #5
LagunaSeca
AF Newbie
Thread starter
 
Join Date: Jan 2017
Location: San Diego, California
Posts: 7
Thanks: 0
Thanked 1 Time in 1 Post
Re: Voltage drop when starting

Yeah, I wasn't so much concerned about the current drop between the battery and the starter. Everything I've read online says 0.2, or 0.6, or 1.0 volt drop under a variety of conditions. If that is correct I should not see less than 11.6 amps at the battery when cranking the engine on the starter. And all my cars must be screwed up. I think that unlikely. It's strange that I cannot find this simple number online somewhere as to an acceptable voltage under starter operation.
LagunaSeca is offline   Reply With Quote
Old 11-08-2017, 01:32 PM   #6
denisond3
AF Enthusiast
 
Join Date: Mar 2007
Location: VA in summer, TX in winter, Virginia
Posts: 1,323
Thanks: 2
Thanked 13 Times in 13 Posts
Re: Voltage drop when starting

When you are measuring voltage drop, dont forget the negative battery cable is just as important as the positive one, and often runs down low in the engine bay, close to water, salt, etc. often the negtive battery cable does not connect directly to the starter, but depends on another length of wire from frame to starter, or frame to bell housing, etc. Some of these connections can be really feeble.


When a franchise shop tells you that you need a starter, I wish I could say that I would believe them. There are honest mechanics and service techs out there, but my wife's sisters have gotten lot of B S from mechanics.
denisond3 is offline   Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums .com Car Chat > Ford > Five Hundred


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 11:51 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts