 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
02-19-2011, 10:56 AM
|
#1 | |
|
AF Newbie
Join Date: Apr 2008
Location: Phoenix, Arizona
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
|
adjusting the plunger on a new idle air control valve
97 Jeep Grand Cherokee Laredo 4.0L
When I went to replace my IAC it was in pieces. I have no idea what the original length of the plunger was. I don't want to ruin the new one. My question is, does anyone know where to adjust the plunger to the proper length before install? Last edited by aksalmonslayer; 02-19-2011 at 02:02 PM. |
|
|
|
|
03-03-2011, 12:02 AM
|
#2 | |
|
AF Regular
Join Date: Jan 2005
Location: Big Pine Key, Florida
Posts: 138
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: adjusting the plunger on a new idle air control valve
not 100% on this but it should do it on it's own. I know OBD1 vehicles you had to do some crazy stuff to (I found out after going through three of them). But it should be good to go with a computer reset. (Others feel free to correct me if I am wrong on this) The pieces you saw were the thing falling apart instead of destroying itself.
|
|
|
|
|
|
03-14-2011, 06:46 PM
|
#3 | |
|
AF Regular
Join Date: Mar 2007
Location: Spencer, West Virginia
Posts: 211
Thanks: 0
Thanked 1 Time in 1 Post
|
Re: adjusting the plunger on a new idle air control valve
Just pop the new one in. It will take a few times of starting the jeep but it will reset on its own or you could do a computer reset but really not necessary.
|
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||
|
POST REPLY TO THIS THREAD |
 |
|
|
