 |
 |
 |
|
|
 |
| Search | Car Forums | Gallery | Articles | Helper | AF 350Z | IgorSushko.com | Corporate |
 | | ||
| |
|
| Latest | 0 Rplys |
|
|||||||
 |
 Show Printable Version |  Email this Page | 
Subscribe to this Thread
|
|
|
Thread Tools |
04-12-2008, 05:10 PM
|
#16 | |
|
AF Newbie
 
Join Date: Mar 2008
Location: Florence, Mississippi
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: lumina "bucks" above 50mph then dies when brakes applied
i just shorted the pins on the diagnostic port. the only code i got was a 23. i googled it but havent found anything yet.
__________________
"the light that burns twice as bright, burns half as long." |
|
|
|
|
04-12-2008, 06:45 PM
|
#17 | |
|
AF Newbie
Join Date: Mar 2008
Location: Florence, Mississippi
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: lumina "bucks" above 50mph then dies when brakes applied
disregard that last post. the code 23 is for air inlet temp. i had disconnected it when i took the breatherbox off.
__________________
"the light that burns twice as bright, burns half as long." |
|
|
|
|
|
04-13-2008, 03:03 PM
|
#18 | |
|
AF Newbie
Join Date: Mar 2008
Location: Florence, Mississippi
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: lumina "bucks" above 50mph then dies when brakes applied
should the service valve remain under pressure after the car has been shut off for a good length of time?
I checked the pressure again today and left the guage connected after engine was shut off. when i returned an hour later the pressure was gone.
__________________
"the light that burns twice as bright, burns half as long." |
|
|
|
|
|
04-15-2008, 12:25 PM
|
#19 | |
|
AF Newbie
Join Date: Mar 2008
Location: Florence, Mississippi
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
|
Re: lumina "bucks" above 50mph then dies when brakes applied
i really thought that i was on the edge of a breakthrough this morning. . .
this problem existed before i replaced the plugs and wires. when i replaced the plugs and wires i wrote down the order that they were in. 1-4-3-6-2-5 and put them back the same way. this morning i noticed under the hood that the firing order is 1-4-6-3-2-5. so i swapped the 3&6 now the firing order is correct. i drove the car for a while before it started missing, but it didnt seen to be as bad. but it still does it.
__________________
"the light that burns twice as bright, burns half as long." |
|
|
|
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
