1997 VW Jetta for sale in PA

[protzler]

I have a 97 Jetta 2.0 with mods that I would like to sale. Here is a list of the mods I currently have:
Golf front end
Boser hood extension
Kamei Air ducts in the bumper
Badgeless grill (Bonrathh. With slats)
ABD Big bore intake
GIAC chip
Neuspeed intake bracket
Some generic filter (WooWoo!! )
ABD strut braces front and back
Front zoll plate
Smoked turns and top half of tail lights (and side bumper markers)
Eibach Springs
16x7 inch BBS RK look-a-likes. One is bent and cracked but am going to see if I can have it repaired. Cars on stocks right now
Wings West touring wing
Euro headlight Switch
Sparco shift knob
Sparco Rev seats (they have to come out though, I'm making barstools out of them. I'll put the stock seats back in.)
Euro rear license plate tub
Alpine headunit. It is the CDA-9815
Aftermarket speakers...Digital Audio. They aren't that great.

The car was just repainted. When it was done, I had them pull all the dings and all that stuff. The colour is Windsor Blue, and it has a beige interior. There are around 80,000 miles on the car currently.
There are a few rock chips in the hood, but thats it.
In the pictures, you will notice that some of the moldings are off the car. These are now fixed.
The pinstriping is only a decal. Can be taken off. I will do this if the buyer wishes.

Some bads:
Sunroof only pops open. From what I understand, it needs a little rubber piece to work again. The interior is also dirty. I will have it cleaned when I trade, but as you will see in the pictures, its kinda nasty. There are two small holes in the dashboard, where I had a tach mounted. There are some cigarette burns in the vehicle also, but nothing exceptionally bad.
On the rear bumper, where I had an exhaust (stock is back on it now), it melted the bumper a little bit. Nothing bad though.

I am the origonal owner of the car also, if that helps...

I would like to get 5500 out of it, but if thats not possible, I can go as low as 5000.

If you don't like the touring wing, a stock wing will fit in the existing holes.

Please drop me a line at p.m.rotzler@iup.edu, as I'm not sure how often I will be able to bump this.

Here are the URL's for the pics:
http://www.people.iup.edu/dxxl/mine1.jpg
http://www.people.iup.edu/dxxl/mine2.jpg
http://www.people.iup.edu/dxxl/mine3.jpg
http://www.people.iup.edu/dxxl/mine5.jpg
http://www.people.iup.edu/dxxl/mine6.jpg
http://www.people.iup.edu/dxxl/mine7.jpg
Thanks for looking!