2004 Dodge Intrepid P0172 Running Rich Problem

[dodge2013162]

Hello,

I am hoping someone can give me some insight on my problem I am currently having. I bought this Ex-Police Car about a week ago and it runs and drives perfect. The only problem I am currently having is that when I had the codes read it was P0172 which tells me the car is running too rich. Basically led me to the BANK 1 O2 Sensors. The Upstream ones on either side of the engine. I just went and spent over $100 on those 2 sensors. Driverside installed and tightened just fine, however, I did not notice until after replacing the passenger side (which are both before the cats) that when I went to install and thread the new one, I figured out that the stupid previous owner obviously didn't care and stripped the threads that the O2 sensor threads into. My question is if anyone can help me out and let me know if I now need to replace the exhaust manifold or what. Any help or input I would appreciate greatly. What would cause the P0172 code on top of O2 sensors? Thanks for any advice

[hundahunta]

make sure you install oem sensors

[dodge2013162]

So they have to be Mopar O2 Sensors? Cause the ones I put in are Bosch. Another thing I did too was used Seafoam in the Main Induction Line and a it was pretty cloudy around my house afterwards. So im assuming there was some major buildup. I don't know if the Seafoam made it worse or what cause I've always used the stuff on all my vehicles I've owned and never a problem. This is really confusing me as I've had 3 cars with this same engine and never an issue like this. Do you know also if Bank 1 is on the Passenger Side. Cause im being told one minute Driver Side and next its the Passenger Side. Just want it running good again. And im being told I can get a "Heli-Coil" to fix the messed up threads on the passenger side Exhaust Manifold where the O2 Sensor threads into.