h22

I HAVE THIS BIG QUESTION IM GOING TO SWAP A H22 INTO MY 91 ACCORD I HAVE THE ENGINE,TRANNY AND ECU.I WAS TOLD THAT ALL THE WIRING HARNESSES ARE THE SAME AND THEY ARE:D BUT I WENT TO THE WWW.H22.ORG HOMEPAGE AND THEY CHANGE THE DISTRIBUTOR TO EXTERNAL CAUSE HIS DISTRIBUTOR WAS INTERNAL:bloated: BUT MINE IS INTERNAL SAME AS THE H22 I HAVE SO IS THAT OK?:( AND I WAS THINKING IF SOMEBODY HAVE THE WIRING DIAGRAM OF THE ECU OF THE H22 OR THE WIRING FOR MY F22 ECU??????:)

Do youplan on putting an MSD on there? If so, don't sweat the internal to external, just get your MSD and put the external coil. I had the same thing happen and when my coil burnt out, we replaced it and it was almost 300 bucks, and then 2 months later I ended up putting and MSD on and found that it was just as easy to buy the external coil for 50 bucks and hook it up. So I kinda wasted money from the get go. I still have my internal coil, let me know if you still need one, if its the same one, I would be happy to sell it to you, as it just sits in my box of excess parts.. importracer151@earthlink.net. As far as the wiring of the external distributor, its too easy. The wiring of the engine and the ECU, it is helpful to have the pin-outs of the ECU, you can request these from Honda, it may cost a few bucks, but it beats guessing.. Good Luck