windshiel wipers
csl849
09-24-2006, 12:11 PM
i have a 97 yukon wipers only work on high. is this the wiper pulse module or something else. thanks in advance.
bcopeland
09-24-2006, 08:07 PM
Sounds like the wiper motor is kaput!
csl849
09-25-2006, 09:49 AM
i was hoping i wouldnt here that. that module is a good bit cheaper
LEsnow
09-26-2006, 08:37 PM
Before you spend any money on a new motor check into recalls. My '96 was covered under a recall. The module developes a crack on the circuit board and the wipers start to act funny.
bcopeland
09-26-2006, 08:45 PM
Very good point!
csl849
09-28-2006, 01:14 PM
No such luck on the recall guess ill have to bite the bullet
MT-2500
09-28-2006, 01:36 PM
i have a 97 yukon wipers only work on high. is this the wiper pulse module or something else. thanks in advance.
If it is the module a drop of solder on the circuit board crack usually fixes them.
They usually crack where the power feed goes threw the circuit board.
MT
If it is the module a drop of solder on the circuit board crack usually fixes them.
They usually crack where the power feed goes threw the circuit board.
MT
LEsnow
10-02-2006, 09:08 PM
Also, check your grounds. The motor housings are cast aluminum and where they connect to ground gets corroded. Disassemble them and clean them with sandpaper, etc.
Automotive Network, Inc., Copyright ©2025