Recently installed lift/ 2nd generation Rodeo

I just had the springs installed that I purchased from independent4x.com and I also cranked the torsion bars to match the 3" lift from the springs. I have the Explorer Pro Comp ES-9000 shocks and the steel braided brake lines that they sell as well. Problem is, it appears that the passenger side of my 2001 Rodeo LS is about 1/4 of an inch higher than the drivers side. I am measuring from the ground to the bottom of the fender. The coils were installed about 48 hours ago so maybe they are not settled yet? i don't know, that's why I am posting. Any suggestions and/or advice is greatly appreciated.

thanks,

Mike

it could also be your torsion bars have settle more on the drivers side over the years. crank the drives side up (I think it is 4 turns = 1/4"?) or the passenger side down.

Then make sure you get your alignment done asap.

Thanks a bunch Ryan. I have put about 50 miles on it now and I plan to measure again tomorrow and then get it aligned on Tuesday.

could you post some pics or email me some thinking of doing a lift on my 93 want to compare